HOME
Rear End Support 2
Stand to support bike frame in car without rear wheel
You usually keep the rear wheel on the frame when storing it on VERGO-Excel in your car, but depends on the car size (especially on compact cars), you need to remove the rear wheel too.
At this moment, the front chain ring will have to touch the carpet and it will stain or give damages to the carpet.
And this style sometimes cause a damage to the rear derailleur by other cargo, and in worst case, the bike frame may be damaged because of unstable frame mounting.
Rear End Support 2 lifts up and holds the bike frame stably to avoid such scratching problem by the chain ring.
The main bar has shims on both ends. By changing the shim direction, Rear End Support 2 will fit 120 / 130 / 135mm rear hub clearance frames.
The caster wheel helps to push the bike smoothly when storing in your car.
Rear End Support 2 can be used on any in-vehicle mounting systems.
Rear End Support 2
Specs
SKU |
423-2350-00
|
|---|---|
Material |
Alloy
|
Color |
Silver
|
Axle Height |
293mm(from wheel axle to floor level)
|
Net Weight |
0.4 kgs
|
Cautions
Important Notices
Tighten the quick release skewer as strongly as possible to hold the bike maximumly stable. If the skewer is loose, the bike frame will have to lie down and the chain ring will touch and hit the carpet. If you need to set Rear End Support 2 in angled position due to the limited cargo space, we recommend to put a paper cardboard underneath the front chain ring. |
|
|---|---|
Precisely adjust the main bar width to fit your bike frame perfectly. Any other frame which rear hub width is not 120, 130 nor 135mm cannot be used. Wrong size adjustment will cause damage to your bike frame. |
Data Download
Jump to [Data Download] page 