Minoura Japan – Gravity Stand

Gravity Stand (Ver.2)

The simplest installation display stand

GravityStand is the simplified stand similar to P-500AL that holds 2 bikes in multi level. Just lean the stand against the wall, then the installation is completed. It's quite easy.
Bikes are supported with two hooks on top-tube.

The latest ver.2 has the modified hooks. It's low-profile design for easier hooking the bike and padded hook protects the bike finish from scratch problem.

The bike cradles are easily position adjustable in 3 positions without any tool.
Each cradle can be locked securely so you don't need to worry about the bike stability.

gravity2_blank.jpgGravity Stand 2
GravityStand2_bike.jpggravity_dimensions-1.jpg

Click to enlarge images

Leaning To Wall

The simplest installation

GravityStand cannot be set in the room center. Once it's leant to the wall, it supports up to 2 bikes securely.

The legs are widely open to support the load. Its length and angle are deeply considered to prevent falling down problem even at earthquake. The stability is incredibly good.

Position Adjustment of Bike Cradle

It's easy and no tool required

The bike cradle on GravityStand is different from any similar bike stands. It doesn't require tool to adjust the position (height).

Pull out the plastic lock lever on foot of the cradle support arm, then the lock will be released. You can remove it from the pillar.
There are 4 holes for each cradle, and you can choose from 3 different positions. Each difference is 60mm.

After changing the cradle position, push the lock lever toward the pillar, then it will be securely locked.

New Cradle Hook

Modified low-profile type hook

The hook for holding the top-tube has just been modified on its design to be low-profile type.
By expanding the area of the hook where touches the frame directly, it becomes gently supporting the bike. The hook is soft foamed urethane padded to avoid scratching bike finish.

The new low-profile hook design also allows you to hook the bike much easier than before. You don't need to lift up the bike so much.

Each hook is angle and position adjustable to fit any bike frame perfectly.

Cautions

Important Notices

  • GravityStand holds up to 2 bikes. You cannot add any more cradles.
  • GravityStand uses the friction between the floor and the rubber foot caps, so the floor condition must be clean and dry. Wet or slippy condition floor due to liquid or sands is not good to setup GravityStand.
  • GravityStand is designed to accept the heavy shock like earthquake, but if you hit the stand or bike, it could fall down. We recommend you to fix the pillar top to the wall with the supplied strap.

Specs

  • SKU 420-1010-00
  • Pillar Height 2,140 mm
  • Color Titanium
  • Material Steel
  • Net Weight 5.5 kgs
  • MSRP US$99.99

Modified Point from Previous Model

Bike Cradle Hook Design (ver.1 --> 2)
Changed from narrow hook to wide low-profile one

Data Download

  • Instructions Manual (PDF 304KB) Doticon_grn_Down.gif