HOME
BH-100S
Quick clamping type extra bottle cage holder
A holder mounting an extra water bottle on your handlebar or seat post.
The newly designed quick clamp (named "SpaceMount") allows installing/releasing the holder in just one action, so you can carry an extra water bottle at anytime you need.
BH-100 series has 2 models with different clamp size.
BH-100S has the smaller clamp band.
BH-100S |
Fits diameter between 22 - 29mm
Red logo printing color
Fits standard handlebar and seat-post
|
|---|---|
BH-100M |
Fits diameter between 28 - 35mm
Black logo printing color
Fits oversized handlebar and fatter seat-post for mini-velo
|
The holder has gear system inside and it allows adjusting bottle cage angle in every 12 degrees. With this feature, you can set the bottle vertically even on the angled position. Also you can set at your desired angle for easier approach.
The holder is made of rust-proof stainless steel and the clamp body is made of light alloy for avoiding getting rusted.
Comes with two bottle cage mounting screws.
BH-100S (22~29mm)
New Quick Clamp
Universal type without acquiring any tool
The previous stainless band which was adopted on BH-95X was great to fit wider diameter range from 22 to 35mm in just one SKU, but it required some technique for installing properly and a tool, so you were not allowed to set and remove the holder so easily.
This newly designed quick clamp (named "SpaceMount") enables to set and remove without any tool, so you can carry an extra water bottle only when you need it.
By screwing the bolt on foot of the clamp body, it will change the diameter easily and will fit various sizes of tube diameter. After adjusting the clamping size, just flipping down the lever, it will hold securely.
S-sized clamp covers 22 - 29mm diameter and it will fit to standard 22mm handlebar or 27mm seat post. Also you can install on the drop-bar over the bar-tape.
M-sized clamp covers 28 - 35mm diameter and it will fit to 32mm oversized handlebar or 32 - 35mm fatter seat post on mini-velo.
Specs
- SKU 339-3100-00
- Clamp Diameter 22 - 29 mm
- Logo Print Color Red
- Material Light alloy & Stainless steel
- Net Weight 79 grams
Cautions
Important Notices
- Adjust the clamp size first by screwing the bolt before closing the lever. It is possible to tighten the screw after closing the clamp, but it will not give enough strong clamping power and the holder may be loosened while riding.
- Make sure the adjusting screw is fully inserted into the clamp body. If the bolt is loosened, you cannot expect enough clamping power.
- When raising up the lever, do not apply the nail only to avoid injury. The lever is held strongly. Do with your finger.
- To adjust the bottle cage angle, you need to loosen the center bolt. If you use Minoura bottle cage, you can do without removing the bottle cage from the holder. But if you use any other brand cage, you must remove it first.
- The clamp may compress and break the outer cable due to its strong clamping power if you install BH-100 on the handlebar together with the cable. Clamp the handlebar only.
- Not compatible with any other dimension than true circle.
- No tool attached. Prepare an M3 hex wrench by yourself. You are not allowed to use any folding tool kit due to the special design. Use the standard L-shaped hex wrench.
- Minoura will not be responsible to any trouble due to the quick release function. We recommend you to remove the holder whenever you need to park the bike.
- Not comes with bottle cage.
- Wind the attached transparent sheet around the installing position to prevent scratching problem.